The URL can be used to link to this page

Home My WebLink AboutAIR CARE COLORADO - PDP - 2-10 - CORRESPONDENCE - (14)2006 International Fire Code 505.1 Number: 35 Created: 2/2/2010 IDENTIFICATION OF FIRE PROTECTION EQUIPMENT Fire protection equipment shall be identified in an approved manner. Rooms containing controls for air-conditioning systems, electrical rooms, sprinkler risers and valves, or other fire detection, suppression or control elements shall be identified for the use of the fire department. 2006 International Fire Code 510.1 Department: Stormwater-Water-Wastewater Issue Contact: Wes Lamarque Topic: Stormwater Number: 36 Created: 2/3/2010 [2/3/10] Although the swale provides some water quaility mitigation by disconnecting impervious service, it does not provide sufficient water quality treatment. Bio-swales would be better, but extended detention is the preferred treatment. Bio-swales may be more expensive and harder to maintain than extended detention and there is sufficient space for extended detention. Please contact Wes at 416-2418 to discuss. Number: 37 Created: 2/3/2010 [2/3/10] The front quarter of the site free releases without water quality treatement. The landscaped area near the type-r inlet could be a location for water quality treatment. Please contace Wes at 416-2418 to discuss. Department: Zoning Issue Contact: Gary Lopez Topic: Zoning Number: 19 Created: 2/2/2010 [2/2/10] The building does not meet building placement standards in LUC 3.5.3(B)(2); refer to Build -to lines. Number: 20 Created: 2/2/2010 [2/2/10] Sign approval shall be on separate permit and based on LUC 3.8.7 Number: 21 Created: 2/2/2010 [2/2/10] Trash enclosure wall surface will need to match building surfaces. Number: 22 Created: 2/2/2010 [2/2/10] What is the building wall treatments... more metal, drivit Etc? And what color of all walls, fascia & roof? Mechanical screening on room must match or complement roof color. Number: 23 Created: 2/2/2010 [2/2/10] Landscaping notes need to include language related to Cert. of Occupancy will not be issued with completion of landscaping or financial security of bond, escrow, or letter of credit for 125% of the landscaping (materials/install total). Number: 24 Created: 2/2/2010 [2/2/10] All lighting, building/pole mounted, must meet LUC 3.2.4. Number: 25 Created: 2/2/2010 [2/2/10] Two HC parking spaces required, none shown. Per LUC 3.2.2(K)(5) Page 5 ❑ Maintain the required minimum width of 20 feet throughout the length of the fire lane (30 feet on at least one long side of the building when the structures is three or more stories in height). If the building is equipped throughout with an approved automatic fire -sprinkler system, the fire code official is authorized to increase the dimension of 150 feet. NOTE: The "fire lane" location shown on the site plan is acceptable. It must also meet the above requirements for dedication, signage, construction and maintenance. 2006 International Fire Code 503.1.1, 503.2.3, 503.3, 503.4 and Appendix D Number: 28 Created: 2/2/2010 HMIA AND OCCUPANCY TYPE: Thank you for submitting the Hazardous Materials Impact Analysis. The amounts, use/storage and containment will determine occupancy type (S-1 vs. H) and related requirements. Number: 29 Created: 2/2/2010 SPRINKLER REQUIREMENTS This proposed building shall be fire sprinklered. 2006 International Fire Code Section 903 Number: 30 Created: 2/2/2010 FIRE DEPARTMENT CONNECTION Fire department connections shall be installed in a pre -approved location and located on the street or fire lane side of buildings, fully visible and recognizable from the street or nearest point of fire department vehicle access or as otherwise approved by the fire code official. 2006 International Fire Code 912.2 and PFA Fire Prevention Bureau Policy Number: 31 Created: 2/2/2010 KEY BOXES REQUIRED Poudre Fire Authority requires a key box ("Knox Box") to be mounted in approved location(s) on every new building equipped with a required fire -sprinkler system or fire -alarm system. PLEASE NOTE: One Knox Box will be required to be installed near the main entrance. Depending on location of the riser room, an additional Knox Box may be required (mounted on the exterior of the building). 2006 International Fire Code 506.1; PFA BUREAU POLICY 88-20 Number: 32 Created: 2/2/2010 FIRE LINE REQUIREMENT Buildings that are required to be fire sprinklered shall have a minimum 6-inch fire line unless hydraulic calculations can support a smaller fire line. NFPA 13 (2007) 23.1.3 Number: 33 Created: 2/2/2010 TURNING RADII The required turning radii of a fire apparatus access road shall be a minimum of 25 feet inside and 50 feet outside 2006 International Fire Code 503.2.4 and Appendix D103.3 Number: 34 Created: 2/2/2010 ADDRESS NUMERALS Address numerals shall be visible from the street fronting the property, and posted with a minimum six-inch high numerals on a contrasting background. (Bronze numerals on brown brick are not acceptable). NOTE: If the address is mounted on a side of the building that does not front the road, the street name is also required to be mounted along with the numerals. Page 4 Light & Power development charges. Please contact Light & Power engineering at (970)221-6700. Number: 2 Created: 1 /20/2010 [1/20/10] Once the plan is approved, an AutoCad drawing of the'utility plan needs to be sent to Pat Colburn. This can be sent via e-mail to PCOLBURN@FCGOV.COM. Department: PFA Issue Contact: Carle Dann Topic: Fire Number: 26 Created: 2/2/2010 WATER SUPPLY Fire hydrants, where required, must be the type approved by the water district having jurisdiction and the Fire Department. Hydrant spacing and water flow must meet minimum requirements based on type of occupancy. Minimum flow and spacing requirements include: • Commercial, 1,500 gpm at 20 psi residual pressure, spaced not further than 300 feet to the building, on 600-foot centers thereafter • Residential within Urban Growth Area, 1,000 gpm at 20 psi residual pressure, spaced not further than 400 feet to the building, on 800-foot centers thereafter • Residential outside Urban Growth Area, 500 gpm at 20 psi residual pressure, spaced not further than 400 feet to the building, on 800-foot centers thereafter. These requirements may be modified if buildings are equipped with automatic fire sprinkler systems. PLEASE NOTE: You can eliminate the hydrant shown on the far, "west" side of the structure. The other two hydrants shown on Sheet C200 WILL be required, with a slight location change for one of them. The FDC would best be located on the south side of the building, near the hydrant shown off the south corner of the building. However, that south hydrant should be moved to the other side of the drive aisle, on the landscape peninsula, so that it's on the same side of the drive as the FDC. That way, an engine can support the sprinkler system (hydrant and FDC) without blocking the drive and cutting off access to other apparatus. The hydrant is needed to support the automatic fire sprinkler system. The second hydrant, shown on the north side of the building, is needed due to the square footage of the structure. The single, existing hydrant located across the frontage road would not be adequate to fire fire in a 15,000-SF building. 2006 International Fire Code 508.1 and Appendix B Number: 27 Created: 2/2/2010 REQUIRED ACCESS Fire access roads (fire lanes) shall be provided for every facility, building or portion of a building hereafter constructed or moved into or within the PFA's jurisdiction when any portion of the facility or any portion of an exterior wall of the first story of the building is located more than 150 feet from fire apparatus access as measured by an approved route around the exterior of the building or facility. This fire lane shall be visible by painting and signage, and maintained unobstructed at all times. A fire lane plan shall be submitted for approval prior to installation. In addition to the design criteria already contained in relevant standards and policies, any new fire lane must meet the following general requirements: ❑ Be designed as a flat, hard, all-weather driving surface (asphalt or concrete) capable of supporting fire apparatus weights. Compacted road base shall be used only for temporary fire lanes or at construction sites. ❑ Have appropriate maintenance agreements that are legally binding and enforceable. ❑ Be designated on the plat as an Emergency Access Easement. Page 3 Number: 10 Created: 1 /28/2010 [1/28/10] According to the Larimer Urban Area Street Standards (LCUASS), no more than 750 sq. ft. may drain across/through a drive entrance measured from behind the ROW line. It appears that with the current design, must more than 750 sq. ft. is proposed to drain through both drive entrances. If the grading can not be altered to bring the drainage area down to below 750 sq. ft. a curb/sidewalk chase will be required. Also, CDOT may also have a maximum drainage area that may be less than the 750 sq. ft. in LCUASS. Number: 11 Created: 1 /28/2010 [1/28/10] Sidewalk ramps must align with each other when crossing drive entrances. Please refer to Transportation Planning's comments regarding the sidewalk and parkway width requirements for this project. Number: 12 Created: 1 /28/2010 (1/28/10] On the grading plan, please show the entire frontage road including any existing drive entrances across the street from this project. Number: 13 Created: 1 /28/2010 [1/28/10] The drive entrance proposed will be required to be built according to Standard Drawing 707 in LCUASS. Provide Drawing 707 in the utility plan set. Number: 14 Created: 1 /28/2010 [1/28/10] On the utility set, are the water services proposed or existing? If they are proposed, please show the approximate limits of the street cut/patch and provide the following statement as a note on the Overall Utility Plan and Grading sheet: Limits of street cut are approximate. Final limits are to be determined in the field by the City Engineering Inspector. All repairs to be in accordance with City street repair standards. Number: 15 Created: 1 /28/2010 [1/28/10] Please label the existing ROW width on the Overall Utility Plan sheet. Number: 16 Created: 1 /28/2010 [1/28/10] The proposed driveway location must be approved by CDOT and will require a CDOT access permit. Number: 17 Created: 1/28/2010 [1/28/10] Signature blocks from Elco and Boxelder may be required for their approval of the project because their.services are being impacted. Also, CDOT may require a signature block on the Utility Plans. Number: 18 Created: 2/1 /2010 [2/1/10] Please see the redlined Utility Plan set for complete comments. Department: Light & Power Issue Contact: Doug Martine Topic: Electric Number: 1 Created: 1 /20/2010 [1/20/10] Light & Power engineering will need a Commercial Service Information (c-1) form completed outlining the characteristics of the electric service. Will also need to coordinate the location for the electric transformer and the name & address of who to invoice for the Page 2 a III/•11 STAFF PROJECT REVIEW City of PortCollins 3� Cuh►MEN%.P BRIAN OJALA Date: 2/3/2010 ENTASIS GROUP 12365 HURON ST., #400 WESTMINSTER, CO 80234 /'�e p rT /C ^7Z Staff has reviewed your submittal for AIR CARE COLORADO PDP - TYPE 1 -3M- (RE:INTERCHANGE BUSINESS PARK LOTS 15 & 16 REPLAT - ENVIROTEST EMISSIONS), and we offer the following comments: ISSUES: Department: Advance Planning Topic: CDOT Number: 4 [1/20/10] Per email from Gloria Hice-Idler Department: Current Planning Topic: Environmental Planner Number: 3 [1/20/101 No comments. Issue Contact: Emma McArdle Created: 1 /20/2010 "both accesses will require access permits." Issue Contact: Dana Leavitt Created: 1 /20/2010 Department: Engineering Issue Contact: Andrew Carney Topic: General Number: 5 Created: 1 /26/2010 [1/26/10] This project is subject to any CDOT requirements and permits regarding the ROW, access points, and/or turn lanes. Number: 6 Created: 1 /26/2010 [1/26/10] Please refer to Transportation Planning's comments regarding sidewalk requirements. Any sidewalk will need to be in either the ROW or an access easement. If the easement is not dedicated on the plat associated with this project it will need to be dedicated by separate document and will be subject to all associated fees. Number: 7 Created: 1/26/2010 [1/26/101 This project will need a Development Agreement as well as Development Construction Permit prior to starting work on site. I have provided the Development Agreement information sheet with this round of review. Once completed and returned to me I will be able to start the Development Agreement language. When the project is closer to final design, we will begin work on the Development Construction Permit. Number: 8 Created: 1/28/2010 [1/28/10] Please include all of the City of Fort Collins General Notes. Numbers 26, 41, 47, & 48 were not included in the Utility Plans. If they do not apply to this particular project they still must be included. Number: 9 Created: 1 /28/2010 [1/28/101 On the Grading Plan, please include spot elevations for all lot corners, and finish floors/top of foundation elevations. pQAF� PaceG'+ / pUT °nl Hot-o i4.r eLFX CaNJuo,��